Services & Links
TAP (Tower Attachment Point)
Higher performance installations, offshore use, ever heavier tower segments for wind turbines. The lifting brackets developed in the past are no longer strong enough; the usual three attachment screws are no longer enough to ensure lifting capacity. Limit plates with four or more single pressure-tap holes must be additionally fitted to each flange, and these heavy construction solutions can only be handled with the aid of a crane.
The Tower Attachment Point (TAP) was redeveloped for tower segments of up to 100 tonnes with the common bolt pitches from 2.5 – 4.2m flange diameter. Each individual TAP bracket has a load capacity of 25 tonnes at a maximum acceptable angle of 30° to the lifting device. The TAP brackets are drop-forged and are made of high-quality heat-treated steel. Because of the high-tensile material the brackets weigh a maximum of 30 kg and two people can easily rig them by hand.On the load side, a standard high-tensile shackle with a 25 tonne nominal rating can be threaded into the TAP bracket, making the connection to the usual round slings or wire ropes as simple as possible. The securing of the load has also been considered: multiple lashing hooks can be attached to the TAP bracket simultaneously. On the tower side, the Tower Attachment Point, (TAP) is mounted using 2 x 2 screws with an 8.8 rating of sizes M36, M42 to a maximum of M48. Both long slots are slightly curved to match the radius of the tower (patent pending), allowing mounting to almost any tower segment with a diameter between a maximum of 4.2m and a minimum of 2.5m. As any technician knows, two long slots in the same direction do not work as the fitting could suddenly slip under a full load. This is where the second patent from GKS-AXZION´s development group comes into effect: each long slot has two bevels alongside it which run in opposite directions. The screws are attached to these bevels by means of wedge-shaped tapered base plates. Under lateral tension the load on the screw is increased in the direction ofthe tension, the contact pressure increases and lateral movement becomes impossible.
On our test bed, the forged TAP brackets were tested to 125 tonnes, five times their rated load capacity. The requirements of EN 13155 «Lifting Devices» are therefore exceeded. This proven 5:1 safety factor permits use in the United States. In addition to the brackets mounting with screws from M36, 8.8 has also been fully tested.
|TYP-Types||WLL (ton)||Diameter (m)||Diameter (inches)||DW (kg)||Screws|
|XL||55||3.0–4.5||118–177||30||M36, M42, M48, M52|
|XXL||> 55||> 4.5||> 177||-||-|